ICC IC107PPU6A Manual descarregar pdf

INSTALLATION INSTRUCTIONS

Congurable CAT 6A Unshielded Twisted Pair (UTP) Blank Patch Panel

Step 1: Mount the patch panel to the rack using four (4) #12 rack screws. Step 2: Install the cable management bar onto the rear of the patch

panel. Tilt the bar upwards 45 degrees. Next, insert the tabs on the bar

into the slots on both sides of the panel, then tilt the bar down.

Step 3: Insert the CAT 6A HD modular connectors into the port on the

patch panel. Note: Inspect the connectors to ensure it is fully seated, and

the front is ush with the panel.

Step 4: Secure the cable to the cable management bar using a nylon

cable tie. Note: A slot is designed on the bar, allowing you to insert and

loop the tie around the cable.

Rack

Slot

Cable tie

1 2

Sem comentários

ICC IC107PPU6A Manual